Choose corner for Cornergauge


« Back to message list

Enter your email address to get email updates on this topic. You can stop receiving updates by clicking the link in the update email messages.

Posted by Will Kostelecky on 26th September 2013
I am probably missing something obvious here, but, can I change the corner of a corner chart? I would like to have one in the top left and one in the top right. The default is, obviously, top right!
Posted by RGraph support on 26th September 2013
Hi there,

You can't change the angles in a corner chart - but what you can do as an alternative is specify the start and end angles in either the Gauge or Meter charts. You could then have them side by side. As an example here's a Meter chart that has had its start and end angle adjusted slightly:

dev.rgraph.net/fiddle/view/an-example-of-a-meter-chart

Try the Gauge chart first though.

Richard, RGraph Support
Please remember to link to the RGraph website

Help support RGraph - single site license only £99
   www.rgraph.net/license#single-site
Posted by Will Kostelecky on 26th September 2013
Richard,

Thanks for the uber-fast response. In another case of, I am probably missing something, but, how do I get a signon for dev.rgraph.net so I can see the example? I have looked for a registration link but not successfully!

Cheers,
Will
Posted by RGraph support on 26th September 2013
Hi there,

My mistake - the link should have been:

www.rgraph.net/fiddle/view/an-example-of-a-meter-chart




Richard, RGraph Support
Please remember to link to the RGraph website

Help support RGraph - single site license only £99
   www.rgraph.net/license#single-site

Add a reply

 




« Back to message list
RGraph on social media